Replacing The Gasket; Cleaning; Cleaning The Glass Window; Cleaning The Product - Videotec MAXIMUS MLX Manuel D'instructions

8.2.2 Replacing the gasket

Replace the O-ring gasket of the product with the
one supplied.
Open and close the cover as described in the
chapters above.
Replace O-ring gasket paying attention to position
it correctly.
Fig. 27

9 Cleaning

Before carrying out any type of
intervention, read the "Safety rules"
chapter of this manual.
Frequency will depend on the type of
environment in which the product is used.

9.1 Cleaning the glass window

Cleaning should be done with mild soap diluted
with water.
MNVCMLX_2222_EN

9.2 Cleaning the product

The outside surface of the product must
never be covered in more than 5 mm of
dust.
The cleaning of the product should be
carried out according to the instructions
in this chapter in order to prevent
accumulation of electrostatic charges.
The device should be cleaned using a damp cloth;
compressed air must not be used.
10 Information on disposal
and recycling
The European Directive 2012/19/EU on Waste
Electrical and Electronic Equipment (WEEE)
mandates that these devices should not be disposed
of in the normal flow of municipal solid waste, but
they should be collected separately in order to
optimize the recovery stream and recycling of the
materials that they contain and to reduce the impact
on human health and the environment due to the
presence of potentially hazardous substances.
The symbol of the crossed out bin is
marked on all products to remember this.
The waste may be delivered to appropriate
collection centers, or may be delivered free of
charge to the distributor where you purchased
the equipment at the time of purchase of a new
equivalent or without obligation to a new purchase
for equipment with size smaller than 25cm (9.8in).
For more information on proper disposal of these
devices, you can contact the responsible public
service.
23