Parapet Mounting - Videotec MAXIMUS MLX Manuel D'instructions

Fig. 6 Example of ceiling installation.
Fig. 7 Example of wall or ceiling installation.

6.1.1 Parapet mounting

The product can be installed on a railing.
Fasten the fastening support (01) to its final
installation surface.
Attach the reinforcement support (02) to the
housing support (03) using the M5 screws and the 5
washers supplied. Fasten the 2 supports assembled
as such to the fastening support (01) using the M8
screw (05), the 8 toothed washers and a relevant
spacer (04). Once the final position of the product is
defined, fully tighten the M8 screw (05) and fasten
the M5 screw (08) to block rotation.
The cable connected to the housing could hinder
operations The illuminator can be rotated 180°.
MNVCMLX_2222_EN
05
03
02
08
Fig. 8 Railing fastening with cable input upwards.
05
03
02
08
Fig. 9 Railing fastening with cable input downwards.
Fig. 10 Rear view of completed installation.
Pay attention to the fixing. Tightening
torque: M5 screws, 9Nm (±0.5Nm). M8
screw, 16.5Nm (±0.5Nm).
04
01
04
01
15