Dibo JMB-C+ Serie Mode D'emploi page 123

1 lagedrukslang koppeling
2 veiligheidsventiel
3 hogedrukslang koppeling
Tip: You can use the collected water with antifreeze several times!
At starting the cleaner again:
• Fill the tank with water and start the cleaner.
• Capture the antifreeze till water flows out of the spray gun (see below).
2 O P T I O N : F I L L I N G K I T A N T I F R E E Z E ( S E E P H OTO B E LOW - 1 . 2 3 0.1 0 0 / 1 0 1 / 1 0 2 ) .
First loosen the basket from the water filter. Connect the filling set antifreeze to
the low pressure hose and to the high pressure hose (closed circuit). Put the
cleaner on idle speed and operate the spray gun. Keep the spray gun pressed
till the water flows out of the low pressure hose and there is filled with
antifreeze till the water filter. Turn the basket back on the filter and then push
again on the spray gun. Hold the spray gun until also the water filter (note the
color of antifreeze in the water filter) is filled with antifreeze (+- 20 litres).
Turn off the cleaner and disconnect the antifreeze filling set of the hoses.
The low pressure side is now also filled with antifreeze.
1
DiBO 31
2
3
E N
T U R N O F F