Dibo JMB-C+ Serie Mode D'emploi page 109

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

the water tank. When the side (panels) doors are opened, an alarm message
appears.
6 WAT E R TA N K
The water tank is an reservoir that is assembled between the water system (tap)
and the high pressure pump. The water tank prevents that there may appear
pressure impulses in the water system. Pressure impulses appears by switching
on and off the spray jet. The water tank prevents under all circumstances that
there penetrates chemicals in the water system. The tank has also an overflow
for draining the excess of water and a drain tap at the front of the trailer. We
recommend also to transport the trailer with empty water tank!
7 WAT E R F I LT E R
The water supply is purged with the water filter.
8 B U R N E R M OTO R
The burner motor drives both, the fuel pump and the ventilator.
The burner motor switches on as soon as the burner switch is switched on.
9 F U E L P U M P
The fuel pump is driven by the burner motor. On the fuel pump is an magnetic
valve assembled which makes that the fuel either gets to the burner or gets
back to the fuel tank.
10 V E N T I L ATO R
The ventilator makes sure that there is sufficient air for the combustion and
also for the cooling of the burner wall. The ventilator is driven electrically and is
mounted at the bottom of the burner.
11 I G N I T I O N T R A N S F O R M E R
The ignition transformer is mounted indirectly against the burner chamber.
The ignition transformer makes sure for a continued ignition spark in the burner
chamber.
12 F LOW S W I TC H
As soon as there is sprayed, there is a flow through the flow switch. The switch
controls if there is a flow of water. At sufficient flow the burner can function.
13 P R E S S U R E R E L I E F VA LV E
If the pressure in the water circuit gets to high by unexpected circumstances,
the pressure relief valve opens and the water runs outside through a hose.
14 F R A M E
The frame is made of a iron construction lacquer with vibration isolators and is
mounted on the trailer.
15 R U N D RY P R OT E C T I O N WAT E R TA N K
The run- dry protection is mounted in the water tank. If the level in the water
tank is to low, the motor gets switched off by means of the dry run protection.
The cleaner goes in failure.
16 F U E L TA N K
The fuel tank you can find at the back of the trailer and is equipped with filling
cap and run- dry protection.
17 R U N D RY P R OT E C T I O N F U E L TA N K
The run- dry protection is mounted in the fuel tank. If the level in the fuel tank is
to low, the motor gets switched off by means of the dry run protection.
The cleaner goes in failure.
DiBO 17
E N
O P E R AT I O N    

Publicité

Table des Matières
loading

Table des Matières