Worx WG322E Notice Originale page 14

Fig.4
Fig.4
1
1
When the log is supported on both ends, as
illustrated in Figure 5, cut 1/3 the diameter from the
Fig.5
top (overbuck) (1). Then make the finished cut by
underbucking (2) the lower 2/3 to meet the first cut.
Fig.5
1
1
1/3
1/3
14
Fig.6
When bucking on a slope always stand on the uphill
side of the log, as illustrated in Figure 6. When
"cutting through" , to maintain complete control Fig.6
release the cutting pressure near the end of the
cut without relaxing your grip on the chain saw
handles. Don't let the chain contact the ground. After
completing the cut, wait for the saw chain to stop
before you move the chain saw. Always stop the
motor before moving from tree to tree.
Cordless Chain Saw
2
1/3
2
2/3
1/3
2/3
2
2/3
2
2/3
Fig.6
SYMBOLS
To reduce the risk of injury, user must
read instruction manual
WARNING
Wear ear protection
Wear eye protection
Wear dust mask
Do not expose to rain
Wear head protection
Wear protective gloves
Wear protective footwear
EN