Ribimex Ribiland PRSC600/200N Manuel D'instructions Et D'utilisation page 37

5.9- Tips:
Do not attempt to cut 2 pieces of logs at the same time. One of them may fly up and hit you.
Stack as you work. This will provide a safer work area, by keeping it uncluttered, and avoid the
danger of tripping, or damaging the power cord.
Accumulated cut wood and wood chips can create a hazardous work environment. Never continue to
work in a cluttered work area which may cause you to slip, trip or fall.
Keep your work area clean and tidy.
WARNING! Do not become careless in assuming your knowledge of the tool.
DO not be filled (over repeated use) with a sense of ease and familiarity with the
tool, neglecting strict compliance to the safety instructions given with the tool.
Improper us of the tool or failure to comply with the provided safety instructions in
this manual can cause severe injury.
Remember that a split second of negligence is enough to cause serious damage.
Stay alert for your surroundings and especially for any danger that you may not
hear while using the tool.
VI. MAINTENANCE
B
EFORE ANY INTERVENTION ON PRODUCT
Wear protective gloves to avoid any injury hazard.
Wear protective goggles when cleaning the machine.
Carefully clean the machine thoroughly after each use (eliminate cutting residues, regularly
lubricate the blade by means of oil spray.)
Reminder: Make sure to maintain the machine in good working condition, carry out regular maintenance of the
machine after each use and before storage .Any breach or default of adequate maintenance reduces the life of the
machine and increases the risk of breakdowns and accidents.
To preserve the security system throughout the life of the machine, it is important to perform maintenance and proper
cleaning, DO NOT use non‐compliant replacement parts and do NOT dismantle yourself the machine or change the
security features.
6.1- Sharpening the blade
- After using the log saw for some time or when required, sharpen the blade using a fine-toothed file
and smooth any burrs or crushed area along the cutting edge.
- Use only the blade recommended by the manufacturer for this model. If a blade is damaged, it must
only be repaired by the manufacturer or qualified persons.
- Use only well-sharpened, crack-free and not distorted blades.
- Use only blades that comply with the European standard EN 847-1.
,
DISCONNECT THE PRODUCT FROM ITS POWER SOURCE
.
Page 37 of 38