Ribimex Ribiland PRSC600/200N Manuel D'instructions Et D'utilisation page 36

Have your logs / wood ready to cut positioned tidily where they can be easily reached.
Have a site located to stack the cut wood or load it onto a nearby truck or other carrier.
4. Route the power cord.
Route the power cord from the power source to the log saw in a way that safeguards against tripping
on the cord, or the cord becoming damaged during the work session.
Protect the power cord from impacts, pulling or corrosive materials.
5. Reminder: The log saw is strictly designed for one-man operation.
5.4- Placing the log on the log table (rocker stand)
Prepare the wood to be cut.
Put the wood on the table (rocker stand) so as not to endanger you (e.g. tripping hazard).
If the piece of wood is longer than the table, support it with the log support [3] or with a log trestle for
example. The log support [3] length can be adjusted through the knobs (h).
Note: do not pull the extension rod out of its guiding rail/bracket (g).
5.5- Starting the log cutting saw
Press on switch to start the motor.
Ensure that the saw blade rotates freely.
Never use the machine if the ON/OFF switch is not working properly.
Immediately have any damaged switch repaired or replaced by qualified personnel to avoid a danger.
5.6- Operating the log cutting saw
- Hold the handle with both hands, support the cradle on your thigh and push it slowly and evenly
towards the saw blade, thus the saw blade is revealed.
- Push the rocker table/cradle evenly to ensure the engine speed does not drop.
- Remove the sawn wood from the rocker table before putting on the next piece.
Note - Pressing the cradle forward releases the blade guard which after cutting will return to its initial
position thanks to the traction of the spring (the saw blade is then completely covered).
5.7- Upon completion of work
Upon completing your work:
- Make sure that the rocker stand is back to its initial position.
- Switch Off and unplug machine from power source.
- Follow and respect the maintenance and cleaning instructions.
Warning
- Do not restart the machine when it is shutting down (braking). Observe a 1 min minimum rest period
before restarting the machine.
- If the blade does not stop 15 seconds after turning off the engine, have it checked by an electrician if
the fuse is damaged and must be exchanged.
- Do not use the saw if the switch brake function is not ensured.
5.8- Safe removal of possible blocking
Switch off and unplug the machine.
Check and localize the origin of the blocking.
Remove the blocking while considering all safety instructions.
Check the machine visually and make sure it is not damaged. In particular, the saw blade must not
show any sign of damage.
Page 36 of 37