Vice working table assembly.
Step1 -
use six M8X15 bolts (large semi-circular head & square neck) to assemble the connect
plate [6] for vice working table on main working table.
Step2 -
use six M8X15 bolts (large semi-circular head & square neck) to assemble vice working
table [5] on connect plate [6] (see Fig.4).
Fig.4
Operating Handle and Wood Support assembly
Fig.5 - Slide the operating handle [4] tubes into the brackets of the log supporter (e).
Adjust to requested working height and tighten the rotary knobs (f).
Fig.6- Insert Log Support [3] on the bracket (g) of the log supporter (e).
Adjust to requested length (log length) and tighten the rotary knobs (h).
Fig.5
Fig.6
Page 32 of 33