Adjusting The Sound - JVC KD-AR760 Manuel D'instructions

Adjusting the sound

You can adjust the sound characteristics to your
preference.
1
* Only for KD-AR760.
2
Indication pattern changes as you
adjust the fader or balance.
Ex.: When "FAD" is selected
18
Indication To do:
FAD* 1 Adjust the front
(fader) and rear speaker
balance.
BAL Adjust the left
(balance) and right speaker
balance.
LOUD Boost low and
(loudness) high frequencies
to produce a well-
balanced sound at
low volume level.
WOOFER* 2 Adjust the
subwoofer output
level.
VOL* Adjust the
3
(volume) volume.
1
* If you are using a two-speaker system, set
the fader level to "00."
2
* Only for KD-AR760: This takes effect only
when a subwoofer is connected.
3
* Normally the control dial works as the
volume control. So you do not have to select
"VOL" to adjust the volume level.
4
* Depending on the amplifier gain control
setting. (See page 22 for details.)
Range
R06 (Rear
only)
to
F06 (Front
only)
L06 (Left
only)
to
R06 (Right
only)
LOUD ON
LOUD
OFF
00 (min.)
to
08 (max.)
00 (min.)
to
30 or 50
(max.)* 4