Opening The Printer Cover - Epson TM-J8000 Manuel D'utilisation

English
5. Take the new cartridge out of its
box and wrapping, and insert it
label-side up, as shown in
illustration
on one end of the cartridge keeps
you from inserting it incorrectly.
6. Move the lever back toward the
front of the printer, and close the
cover. Your cartridge is installed.
Note:
For the first cartridge installed in the printer (or the first cartridge
installed after servicing), it takes about two minutes to charge the ink into
the printer system. The POWER light flashes during this operation. The
printer is ready to use as soon as charging is complete (when the POWER
light stops flashing and stays on). After the first cartridge, the printer
takes only about 30 seconds to charge the ink from a new cartridge into the
printer system. The POWER light also flashes during this operation.

Opening the Printer Cover

CAUTION:
There are sharp edges inside the
printer mechanism. Be careful not to
touch them.
When you open the printer cover,
pull it toward you a little, as shown
in illustration
Troubleshooting
The printer does not print.
Check control panel LEDs. (If POWER is flashing, the printer is not
ready.) Check that both printer power switches are turned on.
Check whether the power supply cable is correctly plugged into
the printer and to the power outlet (or the IM, if you are using the
power cable from the IM). If there is still a problem, contact a
qualified servicer.
8 TM-J8000 User's Manual
. The diagonal corner
9
, and lift it up.
10
9
❶
—
10