Test Station Memory; Using The Car Radio - Medion LIFE P62024 Manuel D'utilisation

Test station memory

In some types of vehicle the default assignment of the permanent plus and alternat-
ing plus has been exchanged by the factory for the ISO block A in the ISO plug. This
means that the station memory does not work.
Before finally inserting the car radio, use the following procedure to check whether the
stations stay saved:
 Re-connect the car battery.
 Switch the vehicle's ignition on.
 Switch the radio on.
 Save stations automatically by holding down the A S / P S button for around two
seconds (see „Automatic search for the 6 strongest stations (APS)" on page 67).
 Switch the vehicle's ignition off.
 Switch the ignition on again and test whether the stations are still saved (to do so
press the station buttons 1 to 6 ).
 If the stations have been saved you can insert the radio.
 If the stations are no longer saved you should use an adapter, available from speci-
alist retailers, or arrange for a specialist workshop to modify the cables. In this case
refer to the „Information on the cables" on page 60section.

Using the car radio

 Push the car radio carefully into the slot until it clicks into place.
NOTE!
When inserting the radio make sure that the cables are not bent, squashed
or pulled tight.
 Then put the cover frame on the radio.
58