Toro Power Max 726 Manuel De L'utilisateur page 15

4. Firmly push in the primer with your thumb 2 times
(15°F or -9°C or above) or 4 times (below 15°F or
-9°C), holding the primer in for a second before
releasing it each time (Figure 23).
g018891
Figure 23
5. Rotate the choke to the Choke position (Figure 24).
g018892
Figure 24
6. Move the throttle to the Fast position (Figure 25).
Figure 25
7. Start the machine pulling the recoil starter or pressing
the electric-starter button (Figure 26).
1. Electric-starter button
2. Electric starter plug-in
Note: To use the electric starter, connect a power
cord to the electric starter plug-in first and then to a
power outlet. Use only a UL-listed, 16-gauge extension
cord recommended for outdoor use that is not longer
than 50 feet (15 m).
WARNING
The electrical cord can become damaged,
causing a shock or fire.
Thoroughly inspect the electrical cord before
using the machine. If the cord is damaged,
do not operate the machine. Replace or repair
the damaged cord immediately. Contact an
Authorized Service Dealer for assistance.
Important: To prevent damaging the electric
starter, run it in short cycles (5 seconds maximum,
then wait one minute before trying to start it
again). If the engine still does not start, take
the machine to an Authorized Service Dealer for
service.
8. Disconnect the power cord from the power outlet first
and then from the machine (electric start only).
9. Allow the engine to warm up for several minutes, move
the choke toward the Run position. Wait for the engine
to run smoothly before each choke adjustment.
15
g018893
Figure 26
3. Recoil starter