Intended Use; Screwdriver Safety Warnings; Charger Safety Warnings - Ryobi R4SDP Traduction Des Instructions Originales

Safety, performance, and dependability
have been given top priority in the
design of your screwdriver.

INTENDED USE

The product is intended to be used only
by adults who have read and understood
the instructions and warnings in
this manual, and can be considered
responsible for their actions.
The product is intended for fastening
and removing screws and bolts.
Do not use the product in any way other
than those stated for intended use.
NOTE: It is recommended to use pilot
holes prior to driving screws.
WARNING
Read all safety warnings and all
instructions. Failure to follow the
warnings and instructions may result
in electric shock, fire and/or serious
injury.
Save all warnings and instructions for
future reference.

SCREWDRIVER SAFETY WARNINGS

■
Hold power tool by insulated
gripping surfaces, when
performing an operation where
the fastener may contact hidden
wiring. Fasteners contacting a "live"
wire may make exposed metal parts
of the power tool "live" and could give
the operator an electric shock.

CHARGER SAFETY WARNINGS

■
Before using battery charger, read all
instructions and cautionary markings
in this manual, on battery charger,
battery, and product using battery to
prevent misuse of the products and
possible injury or damage.
■
Do not use charger outdoors or
expose to wet or damp conditions.
Water entering charger will increase
the risk of electric shock.
■
Use of an attachment not
recommended or sold by the battery
charger manufacturer may result in
a risk of fire, electric shock, or injury
to persons. Following this rule will
reduce the risk of electric shock, fire,
or serious personal injury.
■
Do not abuse cord or charger. Never
use the cord to carry the charger.
Do not pull the charger cord rather
than the plug when disconnecting
from receptacle. Damage to the cord
or charger could occur and create
an electric shock hazard. Replace
damaged cords immediately.
■
Make sure cord is located so that it
will not be stepped on, tripped over,
come in contact with sharp edges or
moving parts or otherwise subjected
to damage or stress. This will reduce
the risk of accidental falls, which could
cause injury, and damage to the cord,
which could result in electric shock.
■
Keep cord and charger from heat to
prevent damage to housing or internal
parts.
■
Do not operate charger with a
damaged cord or plug, which could
cause shorting and electric shock. If
damaged, have the charger replaced
by an authorised serviceman.
■
Do not operate charger if it has
received a sharp blow, been dropped,
or otherwise damaged in any way.
Take it to an authorised serviceman
for electrical check to determine if the
charger is in good working order.
■
Do not disassemble charger. Take it
to an authorised serviceman when
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
EL
TR
UK
English | 1