Storing Phrases Frequently Used In Labeling (Phrase Bank); On The Recorder - Sony MZ-R90 Mode D'emploi

2
To label a track, press x.
To label a disc, press the control
towards . or towards N • >
until " : Name" flashes in the
display, then press x.
The track or disc is ready to be
labeled.
3
Follow steps 4 to 6 of "Labeling a
disc during stop" (page 36).
To cancel labeling, press DISPLAY for
2 seconds or more.
Note
When the recording is stopped while labeling a
track or a disc during recording, or when the
recording moves on to the next track while
labeling a track, the input at that point is entered
automatically.
Available characters
• Capital and small letters of the English
alphabet
• Numbers 0 to 9
• !
" # $ % & ( ) * . ; < = > ?
@ _ ` + – ' , / : _ (space)
Relabeling recordings
Follow the steps corresponding to the
labeling method until the disc or track is
ready to be labeled. Enter a new character
over the one you want to change, then
press the jog lever (keep pressing x for 2
seconds or more on the remote control).
Notes
• You cannot relabel premastered MDs or label
MDs that have not been recorded.
• The recorder is able to display, but cannot
label using Japanese "Katakana" characters.
• The recorder cannot rewrite a disc or track
name of more than 200 letters that was created
by another device.
Storing phrases
frequently used in
labeling
(Phrase Bank)
Phrases that you often use in track or disc
labeling can be stored in the recorder's
memory. There are two ways to store
phrases: storing a phrase while
performing the labeling procedure, or
storing a phase using the EDIT menu.
Approximately 40 phrases of about 10
characters each (with a total character
count of about 600) can be stored in the
phrase bank. The actual number will
depend on the length of each phrases.

On the recorder

./>
Storing phrases while labeling
a track or disc
1
Do the procedure "Labeling
recordings" (page 34) to enter a
phrase.
2
After entering the phrase, press X for
2 seconds or more.
"Entry!" appears in the display and
the cursor flashes after the phrase you
just stored. You can then continue
with labeling operation.
Jog lever
N
X
37
-GB