Control Panel; Fan Speed; Humidity Control - Aircare EP9 Serie Manuel D'utilisation Et D'entretien

CONTROL PANEL

This unit has a digital control panel that allows you to adjust fan speed and humidity
level, as well as view information on the status of the unit. The display will also indicate if
the optional Remote Control is in use at the time. Remote is included with models EP9R
500 and EP9R 800, or can be purchased separately and used with any EP9 series unit.
See parts list at back to order part number 1999 .
CAUTION: If a plant is placed on the pedestal, ensure no water is poured onto the
control panel when watering the plant. If water enters the electronic control panel,
damage may result. If controls get wet, let them dry completely and have unit
checked by authorized service personnel before plugging in.
1) The digital controller has a display that provides information on the status of the unit.
Depending on which function is being accessed, it displays relative humidity, fan
speed, set humidity and indicates when the unit is out of water.

FAN SPEED

2) The Speed button controls the variable speed motor. Nine
speeds provide precise fan control. Press the power button
and select fan speed: F1 through F9 proceeding from low to
high speed. The initial default setting is high (F9). Adjust as
desired.
3) The initial default setting is high (F9). Adjust as desired. The
fan speed will display on the control panel as the speeds are
stepped through.
NOTE: When excessive condensation exists, a lower fan speed setting is recommended.

HUMIDITY CONTROL

NOTE: Allow 10 to 15 minutes for the humidistat to adjust to the room
when setting up the unit for the first time.
NOTE: The EP Series has an automatic humidistat located on the
cord that measures the relative humidity in the room. When the
selected humidity level drops 3% below the relative humidity, the
humidifier cycles on and off as required to maintain the selected
setting.
1) At initial startup the relative humidity of the room will be
displayed. Each successive push of the Humidity Control
Button will increase the setting in
Each successive push of the Humidity Control Button will increase the setting in
5% increments. At 65% set point, the unit will operate continuously.
6