Troubleshooting Guide - Aircare EP9 Serie Manuel D'utilisation Et D'entretien

TROUBLESHOOTING GUIDE

Trouble
Unit does not operate on any
speed setting
Light remains on in chassis
after unit has been turned off.
Not enough humidity.
Too much humidity.
(condensation becomes heavy
on fold surfaces in room)
Water leak
Odor
Probable Cause
No power to unit.
Unit has run out of water – fan
will not operate without water is
present.
Refill switch operation/improper
positioning of float assy.
Fill light stays on and when
power is supplied
If unit has overheated, motor
temp-sensing fuse may have
tripped.
Wick is old and ineffective.
Humidistat is not set high
enough
Humidistat is set too high.
Cabinet may have been overfilled.
There is a safety overflow hole in
rear of cabinet.
Bacteria may be present.
11
Remedy
Ensure polarized plug is fully inserted
in wall outlet.
Refill reservoir.
Ensure float assembly is correctly
positioned as described in
Water Fill, page 5.
Take unit to authorized service
station. DO NOT ATTEMPT
electrical repairs yourself.
Replace wick when clogged or
hardened with minerals.
Increase humidity setting on control
panel.
Reduce humidistat setting or
increase room temperature.
DO NOT OVERFILL cabinet.
Correct water level is indicated
inside of cabinet side wall.
Clean and disinfect cabinet following
Care and Maintenance instructions.
Add EPA registered Bacteria
Treatment according to instructions
on the bottle.
It may be necessary to replace the
wick if odor persists.