iwc Fliegeruhr Worldtime Mode D'emploi page 27

Important: Although the watch is water-resistant in pos itions 0,
1 and 2, the crown should always be screwed in again for normal
use (position X).
s e t t i n g y o u r W a t c h c o r r e c t l y
To set your watch correctly, proceed as follows:
– Release the crown by turning it to the left.
– Wind the movement (approximately 20 revolutions of the crown).
– Pull out the crown to position 2. This will stop the movement.
To set the time accurately to the second, it is best to stop the
movement as the seconds hand passes 60.
– Turn the minute hand and the 24-hour world time display for-
wards until they indicate the desired time. The 24-hour world
time display should be set to show the correct times of the
different time zones. Now move the minute hand a few minute
strokes beyond the time to be set. Then position the minute
hand by moving it gently backwards until it is exactly above
the correct minute stroke. This ensures that the minute hand
begins to move immediately when you restart the movement.
– Push the crown back to position 0 to start the movement and,
in doing so, the seconds hand.
– Pull out the crown to position 1.
— 2 7 —
p i l o t ' s W a t c h W o r l d t i m e r