AFG 3.3AE Manuel Du Propriétaire page 8

ASSEMBLY STEP 4
6
7
5
2
NOTE: Be careful not
to pinch any wires while
attaching the console mast.
14
AFG14_3.3AE_5.3AE_7.3AE_OM_r1_4.indd 14-15
HARDWARE FOR STEP 4
PART TYPE
J WAVY WASHER
K FLAT WASHER
B SPRING WASHER
L BUTTON HEAD BOLT
Open HARDWARE FOR STEP 4.
A
Carefully pull the CONSOLE CABLE (5)
B
through the CONSOLE MAST (6) using
8
J
the twist tie located inside the CONSOLE
K
L
MAST (6).
Attach CONSOLE MAST (6) to MAIN
C
FRAME (2) using PRE-INSTALLED
BOLTS AND WASHERS (7).
Slide WAVY WASHER (J) over CRANK
D
(8) followed by PEDAL ARM (9) as shown.
9
Rest pedal arm wheel on guide rail.
B
Attach the PEDAL ARM (9) to the CRANK
E
(8) using 1 FLAT WASHER (K), 1 SPRING
WASHER (B) and 1 BOLT (L).
F Repeat steps D–E on the opposite side of
the elliptical.
ASSEMBLY STEP 5
QTY
2
2
2
2
N 9 10
M
HARDWARE FOR STEP 5
PART TYPE
M FLAT WASHER
N WAVY WASHER
K FLAT WASHER
B SPRING WASHER
L BUTTON HEAD BOLT
Open HARDWARE FOR STEP 5.
A
Slide 1 FLAT WASHER (M), 1 WAVY
B
WASHER (N) and another FLAT
WASHER (M) onto the LOWER LINK
ARM (10).
Slide the LOWER LINK ARM (10) into the
C
PEDAL ARM BRACKET (9).
Attach the LOWER LINK ARM (10) to the
D
PEDAL ARM (9) using 1 FLAT WASHER
(K), 1 SPRING WASHER (B) and 1
BOLT (L).
Repeat steps B–D on the opposite side of
E
the elliptical.
K B L
QTY
4
2
2
2
2
15
5/20/14 9:12 AM