AFG 3.3AE Manuel Du Propriétaire page 6

TOOLS REQUIRED:
F L-Wrench
F Flat Wrench
F L-Wrench/Screwdriver
F Screwdriver (not included)
PARTS INCLUDED:
F 1 Main Frame
F 1 Stabilizer Tube
F 1 Guide Rail Set
F 2 Pedal Arms
F 2 Lower Handlebars
F 2 Upper Handlebars
F 2 Handlebar Covers
F 2 Lower Link Arms With Footpads
F 1 Front Top Cap Piece
F 1 Rear Top Cap Piece
F 1 Console Mast
F 1 Console
F 2 Handlebar Caps
F 1 Rear Cover
F 2 Sets Handlebar Boots (7.3AE)
F 1 Audio Adapter Cable
F 1 Rubber Pad For Media Players
F 1 Power Cord
F 1 Hardware Kit
10
AFG14_3.3AE_5.3AE_7.3AE_OM_r1_4.indd 10-11
PRE ASSEMBLY
UNPACKING
Unpack the product where you will be using it. Place the elliptical carton on a
level flat surface. It is recommended that you place a protective covering on
your floor. Never open box when it is on its side.
IMPORTANT NOTES
• It is recommended that two people work together for ease and efficiency
while assembling an elliptical.
• During each assembly step, ensure that ALL nuts and bolts are in
place and partially threaded. It is recommended you complete the full
assembly of your unit before completely tightening any ONE bolt.
• Several parts have been pre-lubricated to aid in assembly and usage.
Please do not wipe this off. If you have difficulty, a light application of
lithium bike grease is recommended.
NEED HELP?
If you have questions or if there are any missing parts, contact Customer Tech
Support. Contact information is located on the back panel of this manual.
ASSEMBLY STEP 1
1
2
C
B
A
HARDWARE FOR STEP 1
PART TYPE QTY
A BUTTON HEAD BOLT 4
B SPRING WASHER 4
C ARC WASHER 4
Open HARDWARE FOR STEP 1.
A
Attach the STABILIZER TUBE (1) to the
B
MAIN FRAME (2) using 2 BOLTS (A),
2 SPRING WASHERS (B) and 2 ARC
WASHERS (C) on each side.
5/20/14 9:12 AM
11