Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.2.5- Learning transmitter identity code
The repeater Jump can only operates with a single «Transmitter / Receiver»
pair. It is therefore necessary for the repeater to «learn» the transmitter
identity code.
The repeater Jump memory can only store one identity code.
For this procedure, the repeater must be confi gured with the same radio
channel as the transmitter.
The learning procedure is performed using the DIPswitch «confi guration»
and cursor No. 4.
TENS
UNITS
B
A
CONFIGURATION
CONFIGURATION
LD5
Learning procedure of the transmitter identity code :
Turn off the repeater Jump.
1.
Place the cursor No. 4 on «ON» position.
2.
Turn the repeater Jump.
3.
The LEDs LD2 and LD3 fl ash continuously and synchronously. The
4.
repeater is waiting for a radio message.
Emit radio frames using the transmitter to be associated (send a «Start /
5.
Horn» signal, or command).
LD2 and LD3 LEDs fl ash alternately. The identity code is stored.
6.
Place the cursor No. 4 on «OFF» position.
7.
FR
EN
- 40 -
LD4
LD3
LD2
ON
1
1
2
2
CONFIGURATION
DE
3
3
4
5
5
6
6
7
7
8
8
cursor No. 4
«ON» position = Learning the transmitter
identity code
«OFF» position
Jump - 332970C
revision 03
Publicité
Chapitres
Table des Matières
