Operating Principle - Jay Electronique Jump Notice D'installation Et D'utilisation

3 - Operating principle

The Jump radio repeater is designed for use with the JAY Electronique
radio control solutions implementing unidirectional transmission.
The Jump radio repeater is used to relay a radio signal on a channel
chosen by the user.
The Jump radio repeater provides a solution for applications in diffi cult
environments (obstacles, troughs, bumps) where a direct link is not
possible, and in situations where radio performance must be extended to
cover a greater distance or greater area.
The repeater is paired with a device by «learning» procedure (registration
in the repeater of identifi cation code of the equipment with which it is
operating).
The repeater waits for correct radio frames generated by a radio
transmitter, stores them for 100ms, then re-transmits the n (1 ≤ n ≤ 6)
correct received frames. No radio transmission takes place if any incorrect
frame is received, or if the ID code sent has not been programmed into
the repeater Jump.
Important : This operating principle naturally creates a delay of around
100 ms which must be taken into account and added to the system
passive stopping time.
It is possible to select:
- If the repeater transmits on the same radio channel on which it is
receiving (see example of use # 1 on next page)
- If the repeater transmits on a different radio channel than the one
on which it is receiving, in this case, transmission radio channel No =
reception radio channel No +10. See example of use # 2 on the next
page.
DE EN FR
Jump - 332970C
- 33 -
revision 03