General Safety Rules - Jay Electronique Jump Notice D'installation Et D'utilisation

1 - General safety rules

IMPORTANT :
When installing, be sure to take account of the 100ms processing delay which
you must add to the total passive stopping time of the system. See
principle» section.
Before use, you must confi gure the radio channel on which the repeater will
be operating. See
!
It is essential to «learn» the identity code of the equipment with which the
repeater Jump will be used. See
If several « transmitter / repeater Jump / receiver » systems must be installed
!
in the same area, it is mandatory to confi gure them with different working
(receiving) frequency channels. See
Only use one repeater Jump within a «transmitter / receiver» pair, if the
!
transmission frequency is the same as the reception frequency.
It is possible to use several repeaters Jump for a «transmitter / receiver» pair.
!
In this case, the reception frequency and the transmission frequency of the
repeater must be different. See
 Service your equipment and perform all the periodic checks as
may be required by the intensity with which your equipment is used.
Jump - 332970C
revision 03
«Confi guration» section.
«Confi
«Confi
guration» section.
«Confi guration» section.
guration» section.
«Operating
DE EN FR
- 31 -