Installation - RAIS 900 Manuel D'utilisation

English

Installation

It is prohibited to carry out unauthorised alterations to the stove.
There must be plenty of fresh air in the room where the stove is being installed, in order
to ensure proper combustion. Note that any mechanical exhaust ventilation - e.g. an
extraction hood - may reduce the air supply. Any air grates must be placed in such a man-
ner, that the air supply is not blocked.
The stove is equipped with four convection air outlets, which may be connected with suit-
able air ducts to other rooms.
Building Regulations Approved document J gives specific guidance on the required
permanent ventilation into the room for combustion air of solid fuel appliances.
The floor structure must be able to carry the weight of the wood burning stove, as well as
the weight of a chimney, if necessary.
When you choose where to set up your RAIS wood burning stove, you should consider
the heat distribution to the other rooms. This will enable you to get the best use out of
your stove. The stove should be set up at a safe distance from inflammable materials. See
the manufacturer's plate on the wood burning stove.
Installation of stove:
NOTE:
Decision to be taken concerning the placement of the inlets and outlets of the
convection system. The area requirements for convection holes to be kept.
Miscolouring of the wall above the doors and the convection air outlets may
occur due to raising hot air.
RAIS cannot take responsibility for building in or consequential damage.
The stove to be inspected for defects at receipt.
Lift the stove from the pallet to the place of installation on a suitable floor protection. The
stove can be mounted with rack and adjustable leg (buy accessories at your local RAIS
dealer)
The stove is aligned by adjusting screws, so the lower edge of the glass door is in horizon-
tal position and the surface of the door is vertical when the door is closed.
Remove the front plate and door from the stove. Be careful not to damage the glass on
the door. Protect the painted stove body against spray of cement and paint.
Install the uninsolated flue pipe on the flue outlet inside the convection box.
36
RAIS - manual for RAIS 900