Troubleshooting - Rohm DURO-M Traduction Du Manuel D'utilisation Original

10 | Troubleshooting

10 Troubleshooting
Fault
Workpieces are no
longer sufficiently
clamped or become
loose during use.
The runs with an imbal-
ance.
The jaws cannot be re-
placed.
The workpiece cannot
be inserted.
Jaws do not move.
The stroke is not
reached.
Insufficient clamping
force.
108 / 280
Possible cause
The is soiled.
The is worn or dam-
aged.
Jaws are not inserted
centrally.
The jaw guide is dirty.
The workpiece diameter
is greater than the max-
imum clamping diameter
of the jaws.
Jaws are blocked.
Jaws are blocked.
dirty.
Measure
Clean the as far as pos-
sible.
Replace the .
Check jaw position and
correct if necessary.
Clean and re-lubricate
the jaw guide as far as
possible.
Use a larger .
Disassemble and dis-
mantle and drive out
jaws.
Remove, clean and lub-
ricate the jaws.
Clean and repair if ne-
cessary. See .
B1385260 DURO-M