Rohm DURO-M Traduction Du Manuel D'utilisation Original page 62

1 | About this Operating Manual
sequential damage of any type is excluded for damage and operational in-
terruptions resulting from operating errors, failure to observe this Operating
manual or incorrect maintenance by unauthorised personnel.
RÖHM expressly points out that replacement and wear parts not supplied
by RÖHM must be authorised by RÖHM. RÖHM does not accept liability for
unauthorised replacement and wear parts This applies to both product liab-
ility for consequential damage of all types and to liability for damage to
property.
All unauthorised conversions, modifications to the Lathe chuck and/or
changes in conditions are not permitted for safety reasons and exclude
RÖHM from any liability for any damage which may result. If modifications
to the Lathe chuck are necessary or the area of use differs from the inten-
ded use, this must be agreed with the express permission of RÖHM.
The statutory and contractually agreed terms and conditions apply.
The following damage or defects are excluded from the warranty:
▪ caused by the operator due to non-compliance with the written instruc-
tions of RÖHM with regard to
◦ commissioning (e.g. incorrect construction and assembly work),
◦ operation and
◦ maintenance of the equipment (insofar as this maintenance has not been
contractually taken over by RÖHM).
▪ caused by technical operating conditions unknown to RÖHM (e.g.
chemical or electrolytic influences) and/or machine specifications.
▪ caused by natural wear.
▪ caused by force majeure.
▪ caused by incorrect operation of all types or by incorrect use or opera-
tion of the Lathe chuck. This also includes loading beyond the specified
load limits (e.g. speed, pressure, force, etc.).
This also includes damage caused
▪ if the operator or third parties carry out modifications or repairs to the
services / products without prior permission of RÖHM. Excepted from
this are damage or defects which have occurred and which were
demonstrably not due to these modifications or repairs.
▪ which occur due to use of the Lathe chuck under altered operating con-
ditions (e.g. materials, tools, cutting parameters, programs, etc.), in par-
ticular without consulting and obtaining written authorisation from the
seller or RÖHM.
▪ which are due to altered environmental conditions.
62 / 280 B1385260 DURO-M