JVC KD-A925BT Manuel D'instructions page 35

Symptom
The elapsed playing time is not correct.
"Please Eject" appears on the display.
"Not Support" appears on the display
and track skips.
"Reading" keeps flashing on the display. A longer readout time is required. Do not use too many
Noise is generated.
Tracks/folders are not played back in the
order you have intended.
While playing a track, sound is
sometimes interrupted.
"USB-Error," "Remove Device,"
"Power OFF = ON" appears on the
display.
"Cannot Play" flashes on the display. /
"No USB" appears on the display. / The
unit cannot detect the USB device.
"No File" appears on the display.
"Not Support" appears and track skips.
"Read Failed" appears on the display.
"BT FRONT/ BT REAR" cannot be
selected.
No Bluetooth device is detected.
Pairing cannot be made.
Echo or noise occurs.
Remedy/Cause
This sometimes occurs during playback. This is caused by how the
tracks are recorded on the disc.
Insert a disc that contains MP3/WMA tracks.
Skip to the next track encoded in an appropriate format or to the
next non-copy-protected WMA track.
hierarchical levels and folders. / Turn off the power then on
again. / Reattach the USB device again.
Skip to another file.
The playback order is determined by the file name. Folders with
numbers on the initial of their names are sorted in numerical
order. However, folders with no numbers on the initial of their
names are sorted according to the file system of the USB device.
The tracks have not been properly copied into the USB device.
Copy tracks again into the USB device, and try again.
An over-current occurs. Turn off, then turn on the unit.
Check whether the connected USB device is compatible with this
unit. / Reattach the USB device again.
Check whether the device contains playable files.
Check whether the track is a playable file format.
The connected USB device is not working properly. Connect the
USB device again.
Check the <Source Select> = <Bluetooth Audio> setting.
(page 33) / Check to be sure the USB Bluetooth Adapter is
attached.
Search from the Bluetooth device again. / Reset the unit, then
search from the Bluetooth device again.
Make sure you have entered the same PIN code to both the unit
and target device. (page 13) / Disconnect the Bluetooth device
and try pairing again. (page 13)
Adjust the microphone unit's position.
Continued...
ENGLISH 35