Programming Buttons; Software Menu - ABB i-bus EIB Mode D'emploi

Programming buttons

The EIB Delta-Meter has two buttons:
1. 'SET' button: It is used to activate the display menu
[Menu mode] and the submenus [3 Error] and [4 Instr ].
2. 'SCROLL' button: It has two different functions depending on
the length of the push button action.
When the 'SCROLL' button is pressed briefly, you can jump
between the individual items in the respective mode.
In 'Normal mode', a long push button action (>3 s) switches to
'Alternative mode' and from 'Alternative mode' to 'Instrument
mode'. In all other modes, a long push button action acts as a
"Escape" function. (The software jumps back one menu level).
Only one button may be pressed at a time. The commands
are only carried out once the button has been released.
If no buttons are pressed for two minutes during the
programming, the EIB Delta-Meter cancels the action and jumps
back one menu level. This is repeated until the meter returns to
'Normal mode'.
Light sensor: The EIB Delta-Meters have a light sensor. This has
the same function as the 'SCROLL' button if a torch for example
is shone on the sensor. This enables both the meter readings
and programmed values to be queried both in the case of
programmed and installed devices.
It is not possible to modify any settings with the light
sensor.
28
Software-Menu
29