Instrument Tray Holder Support - tecnodent SERENITY NEXT Mode D'emploi

7.13.2. Under feet model.
Figure 16 shows the leg holder with support under the foot.
This accessory can be provided only with telescopic support.
To adjust the holder, proceed as follows:
1. Loosen the handle (1) and modify the support length;
2. Once the desired height is attained, tighten the handle (1) again;
3. To adjust the holder inclination (2), loosen the handle (3), drive
the part to the desired position, then tighten the handle (3) again.
7.13.3. Motorised leg rest supports.
Upon request at the moment of the order, the chair can be equipped
with leg holders with under feet support and motorised movement.
Two kind of movements are available: lifting / lowering (electrically
assisted) and rotation (manual).
OPERATION.
The leg rests can be controlled by a keypad with two buttons, placed
on the side of the seat, and with a handle placed on the rotation pin.
▪
To lift the leg holders, press the corresponding button on the key-
pad.
▪
To lower the leg holders, press the corresponding button on the
keypad.
▪
To rotate the leg holders, loosen the lever, manually rotate the
holder to the desired position, then tighten the lever again.
7.14. I
NSTRUMENT TRAY HOLDER SUPPORT
Figure 18 shows the instrument tray holder.
This accessory is fitted to the colposcope arm tube, fixed with the provided screws A and B. Depending on the accessories
assembled on the chair, specific adaptors may be required; they can be provided upon request.
FIG. 18
2
FIG. 16
FIG. 17
.
– 50 –
Operating instructions
3
1