Transfusion / Infusion Armrest; Leg Supports - tecnodent SERENITY NEXT Mode D'emploi

7.12. T
RANSFUSION
The chair may be fitted with an armrest specifically designed for blood transfusion or infusion.
The component must be mounted onto one of the two handles.
To attach it, simply hook it to the handle and tighten the knob A as shown in fig 13.
FIG. 13
7.13. L
EG SUPPORTS
To hold and move the patient's legs, two kinds of supports can be provided: a model is equipped with under-thigh holders and a
model is equipped with foot holders. The housings for these supports are on the side of the chair, under the seat upholstery.
7.13.1. Under thigh (Göpel) model.
Figure 14 shows the support with under-thigh holder.
To adjust the inclination of the holder (2), loosen the handle (3), lead
the holder to the desired position, then tighten again the handle (3).
This model of leg holder could be provided with different kinds of sup-
port, depending on the operator's needs.
TELESCOPIC SUPPORT (WITH 3 ADJUSTMENTS).
To assemble these supports on the chair, it is necessary to loosen
the handle on the housing A in the chair, insert the knurled tail in this
housing, drive the support to the desired position, then tighten the
handle again.
In order to adjust the supports, proceed as follows:
1. Raise the patient leg;
2. Loosen the handle (1) and modify the support length;
3. Once the desired height is attained, tighten the lever (1) again.
VERTICAL FOLDABLE SUPPORTS (WITH 2 ADJUSTMENTS).
This accessory is advised in case the operator needs to access the
patient frequently from a sideways position and does not intend (or
has no space) to remove the telescopic supports.
To adjust the height, loosen the handle on the chair housing (A), reach
the desired position and tighten the lever again.
/ .
INFUSION ARMREST
.
2
3
A
FIG. 14
A
FIG. 15
– 49 –
Operating instructions
A
1