Quickie SR 45 Notice D'utilisation page 30

Transportability Cont..
Occupant Restraints Instruction:
1. The pelvic restraint belt must be worn low across the
front of the pelvis so that the angle of the pelvic belt is
within the preferred zone of 30 to 75 degrees to the
horizontal.
A steeper (greater) angle within the preferred zone is
desirable i.e. closer to, but never exceeding 75degrees.
(Fig C)
2. The upper torso restraint belt must fit over the shoulder
and across the chest as illustrated Fig d and e
Restraint belts must be adjusted as tightly as possible
consistent with user comfort.
Restraint belt webbing must not be twisted when in use.
The upper torso restraint belt must fit over the shoulder
and across the shoulder as illustrated in Fig D and E.
fig.c
PRefeReD
fig.D
30
fig.A
fig.e
Zone
fig.f
3. The attachment points to the chair are the outer front
side frames just above the castor, and the rear frame.
The straps are fitted into the tie down brackets,
(See Figs G - H)
4. The tie down symbol (Fig F) on the wheelchair frame
indicates the position of the wheelchair restraint straps.
The straps are then tensioned after the front straps have
been fitted to secure the wheelchair.
fig.B
PeLVIc
PoSItIonInG
BeLt
Fig.G
uPPeR
toRSo
ReStRAInt
BeLt
Fig. H
SR45 Rev.1.0