Automatic Recording With Adjustable "Func Cycl" Cycle - Lovibond SD 310 Oxi Mode D'emploi

c) Delete manual recording:
If data is already saved, it can be deleted with the store button:
Press and hold for two seconds: Open the delete menu
or Switch the selection
Delete nothing (cancel the process)
Delete all data sets
Delete the most recently saved data set
Confirmation of the selection, end of the delete menu
10.2 Automatic recording with adjustable cycle "Func CYCL"
If the "Func CYCL" logger function was selected (see "Configuration of the device"),
measurements are automatically required in the interval of the adjusted time cycle. The
logger cycle time is adjustable from 1 s to 60 min (see "Configuration of the device").
Recordable data sets: 8,000. The automatically recorded values can only be displayed on the PC.
a) Start logger recording:
Press and hold for two seconds: Start selection
Then press again: automatic recording is started.
Each save process is signaled by a brief display of 'St.XXXXX'.
In this connection, XXXXX stands for the number of the data set.
If the logger memory is full, the recording is automatically stopped.
b) Stop logger recording:
Press and hold for two seconds: : If a recording is in progress,
the stop menu appears
or Switch the selection
Do not stop the recording (cancel process)
Stop recording
Confirmation of the selection, end of the delete menu
SD 310_2 07/2018
49