Safety Instructions - Lovibond SD 310 Oxi Mode D'emploi

2.3 Safety instructions

This device is built and tested in accordance with the safety provisions for electronic mea-
surement devices. The fault-free function and operational safety of the device can only
be guaranteed if common, general safety precautions as well as the device-specific safety
instructions in this operating manual are observed.
1. Function and operational safety of the device can only be adhered to under the
c l i m a t i c c o n d i t i o n s s p e c i f i e d i n t h e c h a p t e r " Te c h n i c a l d a t a " .
If the device is transported from a cold environment to a warm environment, a fault of
the device function may arise due to the build-up of condensation. In this case, it is nec-
essary to wait until the devices temperature adjusts to the room temperature before use.
2.
If it is suspected that the device can not be used without possibly imposing a danger,
!
it should be turned off immediately and the potential danger be identified before
the device is used again. The safety of the user may be diminished by the device if it
- exhibits visible damages.
- no longer works as specified.
- was stored for an extended period in unsuitable conditions.
In case of doubt, send the device to the manufacturer for repair or maintenance.
3. Be especially careful when connecting the circuitry to other devices the circuitry for con-
nection to other devices. Under certain circumstances, internal connections in foreign
devices (e.g. GND connection with earth) can lead to impermissible voltage potentials,
which can impair the function of or even destroy the device itself or a connected device.
!
Do not operate the device with a defective or damaged power pack.
Risk of death due to electric shock!
This device is not suitable for safety applications, Emergency Stop equipment or
4.
!
applications in which a malfunction could cause injuries and material damage.
If this notice is not observed, severe harm to the health and property damage
may occur.
5. This device may not be used in a potentially explosive environment.
!
Operation in a potentially explosive environment causes an increased
risk of detonation, fire or explosion as a result of spark formation.
SD 310_2 07/2018
33