Safety Warnings - Festool ETS EC 125/3 EQ Notice D'utilisation D'origine

Contents
1 Symbols..................................................... 13

2 Safety warnings.........................................13

3 Intended use..............................................14
4 Technical data........................................... 14
5 Parts of the machine.................................15
6 Operation................................................... 15
7 Settings......................................................15
8 Working with the machine........................ 16
9 Service and maintenance..........................17
10 Accessories............................................... 17
11 Environment.............................................. 17
12 General information.................................. 18
1 Symbols
Warning of general danger
Warning of electric shock
Read the operating instructions and
safety instructions.
Wear ear protection.
Wear a dust mask.
Wear protective goggles.
Connecting the mains power cable
Disconnecting the mains power cable
Do not dispose of it with domestic
waste.
Safety class II
CE marking: Confirms the conformity
of the power tool with the European
Community directives.
Tool contains a chip which stores data.
See section 12.1
Tip or advice
Handling instruction
2 Safety warnings
2.1 General power tool safety warnings
WARNING! Read all safety warnings, in­
structions, illustrations and specifica­
tions provided with this power tool. Failure to
follow all instructions listed below may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
- Only for AS/NZS: The tool shall always be
supplied via residual current device with a
rated residual current of 30 mA or less.
2.2 Machine-related safety instructions
Harmful/toxic dusts can be produced dur­
-
ing your work (e.g. lead-containing paint,
some types of wood and metal). Aontact
with these dusts, especially inhaling them,
can represent a hazard for operating per­
sonnel or persons in the vicinity. Comply
with the safety regulations that apply in
your country. Connect the electric power
tool to a suitable extraction system.
To protect your health, wear a P2 protec­
tive mask.
Always wear protective goggles to protect
against sanding hazards.
Use a residual current protective device
-
when metal grinding, as well as when the
operation of the power tool in a wet envi­
ronment cannot be avoided. In the event of
an electric shock, the protective switch
protects you against life-threatening cur­
rent through the body.
Clean work equipment soaked in oils, for
-
example sanding pad or polishing felt,
with water and allow to dry. Work equip­
ment soaked in oil may combust spontane­
ously.
Attention: Risk of fire! Avoid overheating
-
the grinding material and the sander. Al­
ways empty the dust container before tak­
ing a break. Swarf in the dust bag, microfil­
ter, paper bag (or in the filter bag or filter
of the mobile dust extractor) may sponta­
neously combust in unfavourable condi­
tions such as flying sparks when sanding
metals. Particular danger exists if the
English
13