Beurer BM 55 Mode D'emploi page 27

If you press and hold the M1 or M2 memory button, you
can set the values more quickly.
• Press and hold the Start/stop button
• Choose the desired hour format with the
M1/M2 memory buttons and confirm with
the Start/stop button
The year flashes on the display.
• Choose the desired year with the M1/
M2 memory buttons and confirm with the
Start/stop button .
The month flashes on the display.
• Choose the desired month with the M1/
M2 memory buttons and confirm with the
Start/stop button .
The day flashes on the display.
• Choose the desired day with the M1/M2
memory buttons and confirm with the
Start/stop button .
If the hour format is set as
play sequence is reversed.
for 5 seconds.
.
, the day/month dis-
12h 12h
The hour flashes on the display.
• Choose the desired hour with the M1/
M2 memory buttons and confirm with the
Start/stop button
The minute flashes on the display.
• Choose the desired minute with the M1/
M2 memory buttons and confirm with the
Start/stop button
Operation with the mains part
You can also operate this device with a mains part.
When doing so, there must not be any batteries in the battery
compartment. The mains part can be obtained from specialist
retailers or from the service address using order number 071.95.
• To prevent possible damage to the device, the blood pres-
sure monitor must only be used with the mains part de-
scribed here.
• Insert the mains part into the connection provided for this
purpose on the blood pressure monitor. The mains part must
only be connected to the mains voltage that is specified on
the type plate.
• Then insert the mains plug of the mains part into the mains
socket.
• After using the blood pressure monitor, unplug the mains
part from the mains socket first and then disconnect it from
the blood pressure monitor. As soon as you unplug the
mains part, the blood pressure monitor loses the date and
time setting but the saved measurements are retained.
27
.
.