Cardin Elettronica SL Série Mode D'emploi page 58

4e) Distance from the opening travel limit
• Press PROG/OK to scroll between the available choices:
- 0 steps; 1 step; 2 steps (default setting); 3 steps; 4 steps; 5 steps; 6 steps; 7 steps; 8 steps; 9 steps
• Press the arrow button
choice and move to the next parameter.
Setting the distance from the opening travel limit (encoder count). Once the opening and closing mechanical
travel limits have been detected the programmer will apply this correction in order to prevent the sliding gate
from colliding into the mechanical travel limits after every work cycle.
4f) Gate delay during opening
• Press PROG/OK to scroll between the available choices:
- 0 steps; 1 step; 2 steps (default setting); 3 steps; 4 steps; 5 steps; 6 steps; 7 steps; 8 steps; 9 steps
• Press the arrow button
choice and move to the next parameter.
Setting the gate delay between the two gate leaves (encoder count) in opening and consequently in closing. it
only tales effect if parameter 5n 'Opening direction gate delay' in the options menu is set to 'ON'.
4g) Braking room
• Press PROG/OK to scroll between the available choices:
- Setting 0 = disabled (default setting); Setting 1 = minimum distance
Setting 2 = medium distance; Setting 3 = maximum distance
• Press the arrow button
choice and move to the next parameter.
Setting the braking room towards the end of the closing stage.
to confirm the choice eg. 3 steps. The programmer will save the
to confirm the choice eg. 3 steps. The programmer will save the
to confirm the choice eg. Setting 2. The programmer will save the
58
4e) Distance from open
LIMITED OPENING
3 METERS
DIST. FROM CLOSE
4 STEPS
DIST. FROM OPEN
3 STEPS
4f) Gate delay
LIMITED OPENING
3 METERS
DIST. FROM CLOSE
4 STEPS
GATE DELAY
3 STEPS
4g) Braking room
DIST. FROM CLOSE
4 STEPS
GATE DELAY
3 STEPS
BRAKING ROOM
SETTING 2