Removing Blockages From Brushbar And Spinscrub Brushes; Changing The Brushbar - Vax DualPower PRO ADVANCE W85-PL-T-E Mode D'emploi

Removing blockages from brushbar and SpinScrub brushes

1
Using a pair of
scissors remove
any threads or hair
caught around the
brushbar.

Changing the brushbar

1
Lie carpet washer
on its back exposing
SpinScrub brushes
and brushbar.
5
Undo the four screws on the side brushes.
12
Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
2
Using a crosshead screwdriver remove the top
and bottom screws from each of the rug guards
(metal pins) and remove to get access to the
brushbar.
2
Using a crosshead screwdriver remove the top
and bottom screws from each of the rug guards
(metal pins) and remove to get access to the
brushbar.
CAUTION
! !
3
Firmly pull sides of
SpinScrub cover and
remove SpinScrub
brushes.
3
Firmly pull sides of
SpinScrub cover and
remove SpinScrub
brushes.
6
Pull and slide left side brushes and remove side cap from
brushbar.
4
Remove any threads
or hair caught around
the brushes, rinse
under water to
remove debris.
4
Use a crosshead
screwdriver. Undo
2 screws and remove
belt guard.