Emptying The Dirty Water Tank; Removing And Cleaning The Nozzle - Vax DualPower PRO ADVANCE W85-PL-T-E Mode D'emploi

Emptying the dirty water tank

Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
1 2
Press dirty water
tank release latch,
pull to remove dirty
water tank.

Removing and cleaning the nozzle

1
Remove both tanks and tilt
carpet washer back.
CAUTION
!
3
Pull and lift dirty Empty dirty water
water tank clip to over the sink. Rinse
release lid. Lift to dirty water tank and
remove dirty water lid under water to
tank lid. remove dirt/debris.
2
Lift nozzle release clip
and pull nozzle forward,
separating tabs on nozzle
and carpet washer.
!
4
Clean the filter
screen located at
the back of the dirty
water tank.
3
Rinse nozzle under water to
remove dirt/debris.
5
To re-fit, tilt dirty
water tank and
line up onto carpet
washer. Push back
until it clicks into
place.
4
Replace nozzle by lining up
tabs on nozzle with tabs
underneath front of carpet
washer. Push nozzle down
until it clicks into place.
11