Filling The Water/Solution Tank - Vax DualPower PRO ADVANCE W85-PL-T-E Mode D'emploi

Filling the water/solution tank

Your dirty water tank is fitted with a float. When the dirty water tank is full, or the floorhead is not in contact with the carpet the float will shut off the suction on the carpet
washer. You will be able to hear if this has happened as the motor noise on the machine will increase. Once the float is activated, empty the dirty water tank if full. If the
dirty water tank is not full then turn off your machine at the power switch and wait for the float to settle.
1
Press clean water/solution
tank release button, pull and
lift to remove tank.
5
Tilt clean water/solution
tank and line up onto carpet
washer. Push tank back until
it clicks into place.
TIP - This machine has an auto mix tank so any solution not used can be poured back into the bottle.
Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
IMPORTANT
!
2
Twist solution tank cap
anti-clockwise and remove.
6
Turn wash/rinse dial to
'wash'. The SpinScrub
brushes and brushbar deep
clean your carpets with
water and solution removing
dirt and stains.
CAUTION
!
!
3
Pour required amount of
carpet cleaning solution into
tank. Tighten cap before
returning tank to unit.
7
Plug into mains, press the
On/Off button to switch on.
!
4
Fill the clean water tank with
warm water (max 40'C).
7