Operating Your Carpet Washer; Using The Pre-Treatment Wand - Vax DualPower PRO ADVANCE W85-PL-T-E Mode D'emploi

Operating your carpet washer

1
Press the recline
pedal and pull handle
backwards.

Using the pre-treatment wand

The carpet washer should be in the upright position when using the hose or pre-treatment wand;
1
Turn wash/rinse dial to
'wash'.
8
2 3
Squeeze the trigger
to release solution
and water mix.
NOTE
de-activating the SpinScrub brushes and brushbar.
2
Pull down accessory hose
connector cover.
5
Press and hold trigger
on pre-treatment wand,
spraying evenly over
stubborn stains.
4
For best results Press the boost
apply water/solution trigger to remove
on the forward tough stains.
stroke and release
the trigger to pick up
water/solution on the
backward stroke.
3
Push wand connector into
solution tube port.
15
5
Turn wash/rinse dial
to 'rinse'. Only water
is released to remove
solution residue.
Pre-treating your carpet before
washing will help to remove
stubborn stains. Do not saturate
your carpet.
4
Plug into mains, press the
On/Off button to switch on.
6
Leave the solution for
10-15 minutes before
washing carpet.