Emptying And Cleaning The Dirty Water Tank - Vax DualPower W85-DP-B-E Mode D'emploi

emptying the dirty water tank
iMpOrtant:
All solution must be emptied from tanks when storing the machine.
nOte:
Rinse out tank with clean water and leave to air dry before storing your machine.
1
Remove dirty
water tank.
Cleaning the dirty water tank
iMpOrtant:
Be sure to remove any debris that has accumulated in the screen above the float. If the screen becomes clogged, this may reduce the performance of
your cleaner. For full suction it is important that the quick pour cap is securely in place. If misplaced, suction will be severely affected.
1
Remove dirty
water tank.
3
To clean dirty water tank ducting, place dirty water tank
under a tap and dispense high pressure clean water into
the inlet port of the dirty water tank to loosen debris
that has accumulated.
2
To empty the tank, unplug
the quick spout pour cap
and empty.
2
Open quick spout pour cap and partially fill dirty water tank with
clean water and swirl around to loosen debris.
3
Insert dirty water tank back
into the cleaner.
4
Allow tank to dry completely,
replace quick spout pour
cap and insert dirty water
tank back onto unit.
Warning
Always switch off and unplug
before filling and emptying the
water tanks, or before
connecting/disconnecting the
attachments.
7