Warning; Caution - Vortice VORT PROMETEO PLUS HR 400 MP Mode D'emploi

ENGLISH

Warning:

!
This symbol indicates that care must be taken
to avoid injury to the user
• Follow the safety instructions to prevent any harm to
the user.
• Do not use this appliance for functions other than
those described in this booklet.
• After removing the appliance from its packaging,
ensure that it is complete and undamaged: If in any
doubt, contact a professionally qualified electrician or
a Vortice Service Centre.
• Do not leave packaging within the reach of children or
differently able persons.
• Certain fundamental rules must be observed when
using any electrical appliance:
never touch appliances with wet or damp hands;
never touch appliances while barefoot.
• This appliance is not suitable for use by children or by
individuals with reduced physical, sensorial or mental
capacities, or by inexperienced or untrained
individuals, unless they are supervised or instructed in
its use by a person responsible for their safety.
Children must always be supervised to ensure that
they do not play with the appliance.
• Do not operate the appliance in the presence of
flammable vapours (alcohol, insecticides, petrol, etc.).
• Store the appliance out of the reach of children and
differently able persons after deciding to disconnect it
from the power supply and use it no more.

Caution:

!
Caution: this symbol indicates that care must be
taken to avoid damaging the appliance
• Do not make modifications of any kind to this
appliance.
• The maintenance instructions must be followed to
prevent any damage to and/or excessive wear and tear
of the appliance;.
• Do not expose this appliance to the elements (rain,
sun, etc.).
• Do not leave objects standing on the appliance.
• The interior of the appliance must only be cleaned by
qualified personnel.
• Regularly inspect the appliance for visible defects. If
the appliance does not function correctly, do not use it
and contact a Vortice Service Centre immediately.
• If the appliance does not function correctly or develops
a fault, contact a Vortice Service Centre immediately.
Ensure that only genuine original Vortice spares are
used for any repairs.
• If the power cable becomes damaged, have it
replaced immediately by an authorised Vortice Service
Centre.
• Should the appliance be dropped or suffer a heavy
blow, have it checked immediately by a Vortice Service
Centre.
• The appliance must be installed by a professionally
qualified electrician.
• The appliance must be mounted in such a way as to
ensure that under normal operating conditions, no one
can come into contact with any of the moving parts or
live electrical components.
• Should you need to:
dismantle the appliance with the proper tools;
remove the heat exchanger;
remove the motor module;
the appliance must be turned off and disconnected
from the mains before work starts.
• The electrical system to which the appliance is
connected must conform to applicable standards.
• A multi-pole switch must be used to install the
appliance. The gap between the switch contacts must
be no less than 3 mm.
• The electrical power supply/socket to which the
appliance is to be connected must be able to provide
the maximum electrical power required by the
appliance. If it cannot do so, arrange for a qualified
electrician to make the necessary modifications.
• Switch off the system's main switch:
if the appliance does not function correctly;
before cleaning the outside of the appliance;
if you decide not to use the appliance for any length of
time.
• The appliance cannot be used in combination with
water heaters, room heaters, etc., nor must it be used
to drain hot water away from such appliances.
• The appliance must expel air directly to the outside
through a dedicated outlet.
• The flow of extracted air must be clean (that is free of
grease, soot, chemical and corrosive agents and
explosive or flammable mixtures).
• Keep the appliance intake and outlet grilles free to
ensure optimum air flow.
• Specifications for the power supply must correspond
to the electrical data on ID plate A (fig. 1).
1 1
A
5