Warning - Caution - Vortice VORT PLATT HCS Notice D'emploi Et D'entretien

Table des Matières

Publicité

WARNING - CAUTION

!
Warning:
These appliances are designed
for use in residential and
commercial properties.
• Do not use this appliance for functions other than
those described in this booklet.
• After removing the appliance from its packaging,
ensure that it is complete and undamaged:
If in doubt contact a professionally qualified
electrician or contact Vortice*.
Do not leave packaging within the reach of children
or less able persons.
• Certain fundamental rules must be observed when
using any electrical appliance, including:
a) do not touch it with wet or damp hands;
b) do not touch it while barefoot.
• Do not operate the appliance in the presence of
inflammable vapours (alcohol, insecticides, petrol,
etc.).
• Do not sit on or leave objects on the appliance.
This appliance can be used by
children no less than 8 years of
age and by individuals with
limited physical, sensory or
mental
capacities,
inexperienced
individuals, provided that they
are supervised or have been
instructed in safe use of the
appliance and understand the
associated risks. Children must
not play with the appliance.
Cleaning
and
procedures
undertaken by the user must
not be entrusted to children,
unless under supervision.
The appliance must be
installed by a professionally
qualified electrician.
The electrical system to which
the product is connected must
be
in
compliance
applicable regulations.
An omnipolar switch with a
contact opening distance of 3
mm
or
higher
provided
8
This symbol indicates precautions that must be taken to avoid personal injury
or
or
untrained
maintenance
that
can
should
for
installation,
enabling
disconnection
overvoltage
conditions.
Products equipped with three-
phase
ALWAYS require connection to
380-415V (or only 400V where
required) three-phase lines, or
also 220-240V (or only 230V
where required). Any kind of
modification
considered
tampering and shall nullify the
relative
equipped with single-phase
wiring (M) engines ALWAYS
require connection to 220-240V
(or only 230V where required)
single-phase lines. Any kind of
modification
by
considered
tampering and shall nullify the
relative warranty.
be
with
be
ENGLISH
complete
category
wiring
(T)
shall
as
warranty.
Products
shall
as
under
III
engines
be
product
be
product

Publicité

Table des Matières
loading

Table des Matières