Fitting The Backing Pad And Sanding; Fitting The Wire Brush; Fitting The Cup-Grinding Wheel With Wheel Guard - Metabo W 7-100 Mode D'emploi

02 ENG_Paddle_8830_0108
b
Fit the hand guard (b) over the threaded part of
the handle (5). Adjust the hand guard and fit to
the angle grinder along with the side-handle.
13.3

Fitting the backing pad and sanding

disc
Use only the clamping nut supplied
along with the backing pad.
Locate the backing pad (i) on the spindle, as
illustrated. Mount the sanding disc (k) with the
backing pad clamping nut supplied. Lock the
spindle in position. Tighten the sanding disc and
backing pad by turning clockwise by hand.
Slacken off manually or with the pin spanner (13),
as necessary.
22.01.2008 11:24 Uhr
13.4
Fit the hand guard.
Remove the wheel guard (4). Lock the spindle in
position. Mount the wire brush (f) and tighten with
the 22 mm AF open-ended spanner (7/8").
13.5
Remove the wheel guard (4). Fit the cup-grinding
wheel guard to the angle grinder, turning it on in
the direction indicated by the arrow until fully in
position. Use a screwdriver to tighten the screw.
Locate the inner flange (10) on the spindle,
ensuring that the flange cannot turn on the
spindle. Position the cup-grinding wheel so that it
rests evenly on the inner flange.
Seite 19

Fitting the wire brush

Fitting the cup-grinding wheel
with wheel guard
10
ENGLISH
19