Operation, Switching On/Off - Metabo W 7-100 Mode D'emploi

02 ENG_Paddle_8830_0108
ENGLISH
When fitting the wheel guard (4) to the angle
grinder, ensure that the notch on the wheel guard
coincides with the corresponding marking on the
tool itself.
Turn the wheel guard so that the closed
area is towards the operator.
Connect to mains supply
With VTC / TC electronic system (depending on
equipment):
The red electronic system indicator (6) lights up
briefly when the mains connection is made, thus
indicating standby mode.
8

Operation, Switching On/Off

Always guide the machine with both
hands!
First switch on, then apply the tool to
the work piece!
It must be avoided that the machine
draws in additional dust and shavings.
When switching the machine on and off,
keep it away from dust deposits.
After switching off the machine, only
place it down when the motor has come
to a standstill.
In the case of VTC / TC electronic control:
the red electronic signal indicator (6) comes on
briefly when the machine is switched on.
Machines with slide-switch (1):
(Machines with the designation W... or WE...)
1
Switching on: slide the slide-switch (1) forward
until it engages.
Switching off: press the rear end of the slide-
switch.
Machines with switch lock:
(Machines with the designation W... ...-150 ... or
WE ...-150 ...)
16
22.01.2008 11:24 Uhr
W ...
WE ...
0
I
Seite 16
1
0
I
Switching on: press the rear of the slide
switch (1), then slide forward until it engages.
Switching off: press the rear of the slide switch.
Machines with switch lock
(Safety switch because it cannot be locked):
(Machines with the designation WEP...)
Do not carry or suspend the machine
by the trigger switch (9).
9 8
Switching on: slide the switch lock (8) in the
direction of the arrow and press the switch
trigger (9).
Switching off: Release the switch trigger (9).
Tools with switch trigger (9):
(Machines with the designation WP... or WPS...)
Switching on: slide the switch lock (8) in the
direction of the arrow and press the switch
trigger (9).
Switching off: Release the switch trigger (9).
Continuous operation:
(Machines with the designation WP...)
Switch on the angle grinder and slide the switch
lock (8) forward until it engages.
Switching off continuous operation:
Briefly press the switch trigger (9) and release.
W... ...-150 ...
WE ...-150 ...