Ergon CF3 Pro Carbon Instructions D'installation Et D'utilisation page 62

62
EN
Set the saddle angle 'a' (using your notes or instructions on page 49) and tighten
the clamping screws to 6 - 7 Nm. Do not exceed 7 Nm (Fig. G). The Anti-Slip
Shim must be secure, unable to move. It must be flush to the sides of the post.
Re-fit the seatpost, and the correct saddle height 'b'. Tighten the seatclamp
using the torque setting as described previously. Do not clamp the Ergon CF3
using more than 7 Nm torque (Fig. H). If the seat post still slips when you sit on
it even with the use of the Ergon shim then the post will not work on your frame.
Fig. G: Set the saddle angle 'a' (using your
notes). Fasten the lock screw.
7 Nm
a
b
Fig. H: Fit the seatpost according to the required
extension 'b'. Tight the seatpost clamp.
max.
7 Nm