Ergon CF3 Pro Carbon Instructions D'installation Et D'utilisation page 42

42
EN
Before first use, carefully test all fittings on a short test ride away from
busy streets and vehicles, checking that the seatpost is securely
clamped in the frame and cannot slip. For more information, refer to
page 58 of these instructions.
Should the seat tube have sharp edges / burrs it is possible that the seat
post will be scored and damaged upon installation or upon use and this
will ultimately lead to a seat post failure and a crash. For more
information, refer to page 47 of these instructions.
Ergon Carbon Paste (supplied) or Dynamic Carbon Paste must be used
on the seat post between the carbon leaves and in the seat tube of the
frame to prevent slipping. The seat tube must be clean with no grease or
other lubricants present. For more information, refer to pages 46-47 of
these instructions.
The minimum and maximum insertion for the post are printed on the CF3
seat post. These must be strictly adhered to. Please note, that the frame
manufacturer may require the seatpost to be inserted further than our
minimum marking. Please read the instructions included with your
bicycle accordingly. The correct torque for the seat post clamp bolt on
the frame is usually found on the seat post / seat tube clamp.
Alternatively it may be in the bicycle's instruction manual.