Ergon CF3 Pro Carbon Instructions D'installation Et D'utilisation page 53

ERGON BIKE ERGONOMICS
Adjusting the horizontal position
(fore/aft) of the saddle
The distance from the nose of the saddle to the handlebars can be set in the
usual way by sliding the saddle in the saddle clamp unit. Use your previous
measurements from your old set up. Undo the two saddle clamping screws by
one or two turns. Push the saddle (Fig. A) and note during adjustment the
clamping area of the saddle that is typically delineated by an imprinted scale or
stop markings on the saddle rails. Never clamp the saddle beyond these
delineating marks. Fasten the saddle clamp screws using 4 - 5 Nm. (Fig. B). For
tips on adjusting the horizontal position of the saddle, see page 66.
The CF3 also allows an increase in the adjustment range by turning the entire Flip
Head saddle clamp unit. The following instructions (on pages 54-55) must be
followed when using this method.
Fig. A: Loosen the saddle clamp screws.
Adjust the horizontal position of the saddle.
1-2 x
Fig. B: Tighten the saddle clamp screws to
4 - 5 Nm.
53
EN
max. 5 Nm