Ergon CF3 Pro Carbon Instructions D'installation Et D'utilisation page 43

ERGON BIKE ERGONOMICS
The bolt used to clamp the seat post in the frame must be tightened
using a torque wrench to a maximum of 7 Nm. Do not exceed this
amount regardless of what the frame manufacturer recommends.
When tightening any screws / bolts / fixings on the seatpost the printed
torque settings must be observed. Should two components being used
together (frame / seat post) have different torque values given for
tightening, always use the lower value. A TORQUE WRENCH MUST BE
USED IN ASSEMBLY.
The included Flip Head saddle outer clamps are only to be used with
round saddle rails (7x7 mm steel or titanium). For oval Carbon saddle
rails (7x9 mm) the Ergon Flip Head Adapter for Carbon Rails must be
used (available separately). Please pay particular attention to the saddle
rail compatibility information on page 57. For instructions about removal
of the Flip Head refer to pages 54-56 of these instructions.
• For your own safety, replace the seat post if it has suffered a hard
impact, for example, after an accident or a fall.
• If your seat post creaks or makes cracking or squeaking noises or if
external damage such as notches, cracks, dents, or discoloration, etc.,
can be seen, then you should not use it any longer. Contact your Ergon
dealer and have it checked carefully and replace the parts if necessary.
43
EN