Dometic TEC 29 EV Instructions De Montage page 24

Installation
9.3 External installation
• To find a position where is possible to install the generator, take into consider-
ation:
– Distance from ground
– Considering the drilling needed
– Far enough from vehicle exhaust
– Easy serviceability access
• Mind the center of gravity (fig. 2, page 3) and the lifting points (fig. 3, page 4)
indicated.
• Use the tools shown to install the generator (fig. 4, page 4).
• To ensure the generator is attached securely, use the retaining bracket (fig. 5,
page 5) supplied.
Remove the generator from its chassis
➤ Remove the front access (fig. 6 1, page 5).
➤ Remove the two fixing lateral screws (fig. 6 3, page 5).
➤ Slide out the generator (fig. 6 2, page 5).
Install the enclosure on vehicle
➤ Drill the vehicle floor on the chosen position using the cut off template 8 mm
diameter.
➤ Fix the enclosure with a 8 mm bolt system with washers provided.
➤ Slide in the generator on the chassis and fix it with the two lateral screws
(fig. 6 3, page 5).
9.4 Internal installation
• For internal installation, you need to prepare a sealed compartment against the
vehicle interior which can also be insulated against sound (fig. 7, page 6).
• Leave a space of at least 20 mm between the generator hood and surrounding
parts so that sufficient space remains for cooling air to pass through.
Remove the generator from its chassis
➤ Remove the front access (fig. 6 1, page 5).
➤ Remove the two fixing lateral screws (fig. 6 3, page 5).
➤ Slide out the generator (fig. 6 2, page 5).
24
TEC29 EV
EN