Lenz Digital plus SILVERmini+ Mode D'emploi page 30

30
5.6 Constant braking distance
5.6.1 Constant braking distance with ABC
Functioning: If the decoder recognises the command "Stop" while in ABC mode, the locomotive will
stop after the set braking distance has been covered. This braking distance is independent of the
speed of the locomotive.
5.6.2 Constant braking distance with speed step 0
Functioning: The constant braking distance is only effective if the speed step is set to 0. If the speed
step is decreased from e.g. 28 to 10, the speed-dependent delay from CV3 becomes effective.
You can find detailed information on setting the braking distance in the "Manual Plus Decoders" that
you can download from the Lenz Elektronik GmbH website www.lenz-elektronik.de/download.php
Important advice:
While the shunting speed is switched off (default setting F3), the constant braking distance is
disabled and the delay from CV4 becomes effective.
The constant braking distance is also disabled if the delays set in the decoder are disabled by
means of the corresponding function.
The two latter features can also be used sensibly if you wish to interrupt a current braking process
prematurely.
The constant braking distance does not work if the layout is operated in analogue DC mode.
Information SILVERmini+ S.U.S.I.